Hot melt adhesive coater - use and daily maintenance 2

3、 Matters needing attention when using hot melt adhesive coater

1. When operating the hot melt adhesive coater, do not put other sundries on the machine body or use it as a padded appliance. 2. When moving or lifting the hot melt adhesive coater, only its base is allowed to be used as the handling force point. Never lift the hot melt adhesive coater with the help of the glue pot cover of the hot melt adhesive coater, the electrical box door, the electrical components on the control panel or the joints on the insulation pipe. Abnormal handling will damage the spraying equipment of the hot melt adhesive coater. [safety precautions during maintenance and repair of glue spraying equipment of hot melt adhesive coater] IV. safety precautions during maintenance and repair of glue spraying equipment of hot melt adhesive coater when maintaining and repairing hot melt adhesive coater, the following main safety precautions shall be taken: 1 Before the maintenance and repair of the hot melt adhesive coater, the power supply on the hot melt adhesive coater and the main power supply connected to the outside must be cut off, and live operation is not allowed. 2. During disassembly, maintenance and repair, workers Zui should not wear earrings, watches, necklaces, bracelets and other conductive decorations to prevent accidents. 3. Do not disassemble, check and adjust any he parts on the hot melt adhesive coater, unless you have enough knowledge of the equipment performance. 4. Do not disassemble and repair the hot melt coater equipment alone unless there are other personnel nearby to assist and give immediate help or first aid in case of accident, mechanical damage or personal injury. 5. Only qualified personnel can repair and maintain the hot melt adhesive coater.

6. Under any he circumstances, do not touch wire connectors that may be exposed to the outside world or other components connected by wires and not loosened. 6. Before removing or moving the protective device on the hot melt adhesive coater or replacing the element, the power supply must be cut off. 7. If possible, try to stand on the plastic blanket for maintenance and repair. Never maintain the hot melt coater in a flooded floor or non Chang humid environment. 8. Wear Ann Quan gloves, goggles and long sleeved overalls when maintaining and repairing the hot melt adhesive coater to avoid scalding the body part by high-temperature liquid hot melt adhesive or by high-temperature component surface. 9. When loosening or installing the pressure joint, it must be determined that the pressure of the pressure air supply for the hot melt adhesive coater has been reduced to zero. 10. When cleaning the hot melt glue cylinder, avoid using fireworks or sharp hard tools to avoid scratching the Teflon non adhesive coating inside the glue barrel. 11. In case of air pressure or glue leakage of the hot melt adhesive coater, do not continue to operate the hot melt adhesive coater. First stop the hot melt adhesive coater, cut off the power supply, reduce the operating pressure to zero, and then conduct maintenance.

The above information is provided by the hot melt adhesive coater